Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Pontiac Fiero Base, Standard, MG3FACTORY OEM SERVICE PROCEDURE
Refilling & Bleeding System
- Fill pump reservoir to proper level. Start engine and run momentarily. Stop engine and recheck fluid level. Add fluid (if necessary). Repeat procedure until fluid level remains constant after running engine.
- Raise and support vehicle so front wheels are off ground. Start engine. Turn steering wheel from side to side several times (without hitting stops). DO NOT hold wheel in full left or right position. Fluid level should remain above pump inlet in reservoir.
- Return wheels to center position and operate engine for 2- 3 minutes. Road test vehicle and recheck fluid level. Fluid containing air will have a milky appearance. All air should be eliminated to obtain normal steering.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.