Toe-In Adjustment: Rear

1987 Pontiac Fiero Base, AutomaticSECTION Rear

Adjust rear wheel toe after rear camber has been set. To adjust, loosen boot and lock nut near outer end of tie rod. Rotate tie rod to obtain specified toe. Tighten lock nut.

Fig 1: Toe-In Adjuster Tube Clamp & Bolt Positions
G26714
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.