Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1987FIERO BASE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMFUEL INJECTION SYSTEM - TBIOVERHAULREASSEMBLYTHROTTLE POSITION SENSOR (TPS)
1987 Pontiac Fiero Base, Automatic
Throttle Position Sensor (TPS)
1987 Pontiac Fiero Base, AutomaticSECTION Throttle Position Sensor (TPS)
Place throttle valve in normal closed idle position. Install TPS on throttle body with pick-up lever above throttle actuator lever. Install retainer, lock washers and 2 new attaching screws (coated with locking compound).
NOTE:
TPS adjustment must be done with throttle body installed on vehicle. See appropriate article in TUNE-UP section.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.