SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1987FIERO BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 2 (COMPUTER RELEARN PROCEDURES)RELEARN PROCEDURESTP SENSOR LEARN (CORVETTE)
1987 Pontiac Fiero Base, Automatic

TP Sensor Learn (Corvette)

1987 Pontiac Fiero Base, AutomaticSECTION TP Sensor Learn (Corvette)
WARNING: This page does not describe the selected car, but rather 65 other vehicles, including the 1994 Saturn SW2, 1994 Saturn SW1, 1994 Saturn SL2, 1994 Saturn SL1, and 1994 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.

If a NEW TP sensor or throttle body is installed, EBTCM must learn new TP sensor idle position voltage. This procedure is necessary to ensure effective engine torque reduction during ASR operations. TP sensor learn procedure requires a Tech-1 scan tester or T-100 (CAMS) unit.

  1. Turn ignition off. Connect Tech-1 scan tester with a Mass Storage cartridge. Turn ignition on. Select ABS/ASR feature from menu.
  2. Select F5 (TP SENSR LEARN). Press up arrow to begin learn procedure. Wait for Tech-1 scan tester to indicate COMPLETE. Turn ignition off. Disconnect Tech-1 scan tester.
NOTE: Ensure accelerator and brake pedals are free from any obstructions while performing TP sensor/idle learn procedure. PCM will not perform learn function with accelerator pedal or brake pedal obstructions.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.