Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Pontiac 1000 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Injection Timing
- Rotate crankshaft until No. 1 piston reaches TDC of compression stroke. With upper cover removed, check that timing belt is properly tensioned and that timing marks are aligned. See Fig 1 . With camshaft cover removed, check that fixing plate (J-29761) fits smoothly into slot on rear of camshaft, then remove fixing plate.
- With injection lines removed, remove distributor head screw and washer, located between injection lines on pump. Install static timing gauge (J-29763) on pump opening and set lift at 0.04" (1 mm). Rotate crankshaft to bring No. 1 piston to a point between 45-60Β° BTDC. See Fig 2 . Zero dial indicator.
- Turn crankshaft until 18Β° BTDC line on damper pulley is in alignment with pointer. Dial indicator reading should be 0.02" (0.5 mm). Turn crankshaft in normal direction of rotation, if reading on dial indicator deviates, hold crankshaft at 18Β° BTDC position and loosen nuts on injection pump flange.
- Move the injection pump to a point where proper dial indicator reading is reached and tighten pump flange nuts. Recheck reading and adjust, if necessary. Install distributor screw and washer. Install camshaft cover, fuel injection lines and upper cover. Adjust idle speeds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
