Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Pontiac Grand Prix V6-252 4.1LFACTORY OEM SERVICE PROCEDURE
Computers and Control Systems: Technical Service Bulletins
- Customer Interest
- By Symptom
- All Technical Service Bulletins
- Engine - THIS BULLETIN HAS BEEN CANCELED
- Electrical - MIL ON/DTC's Set By Various Control Modules
- Electrical - Intermittent MIL/DTC P2138/Reduced Power
- Engine, A/T - Shift/Driveability Concerns/MIL ON
- Engine Controls - ECM May Contain Wrong PROM
- Oxygen Sensor - Code 13 Set/MIL ON
- Oxygen Sensor Test - Revised Tech 1 Mass Storage CD
- ECM - Failures
- ECM/PCM - Damaged and/or Mis-Diagnosed
- VSS - MIL ON/Code 24 Set
- Engine Controls - MAP Chart, DTC's 33, 34 ,63 ,64
- EFI Diagnostic Charts - Updated
- Engine Controls - Diagnostic Chart Revisions
- Monitor II - Update Program
- Engine Controls - Static Electrical Damage Precaution
- Revised CCC and EFI Diagnostic Charts
- Overview
- CCC
- *1983 Chart - "Idle Speed Solenoid - Throttle Kicker"
- 1983 Chart - "Code 12, (Except Hall Switch)"
- 1983 Chart - "Code 12 (Hall Switch)"
- 1983 Chart 4
- 1983 Chart - "Code 24"
- 1983 Chart - "Pulse Width Modulated (PWM) EGR Check"
- 1983 Chart - "EGR Valve Check"
- 1983 Chart - "EFE (Vacuum Servo) Check"
- 1982/1983 Chart - "Engine Cranks But Will Not Run (Remote Coil)"
- 1982/1983 Chart - "Engine Cranks But Will Not Run (Integral Coil)"
- 1982 Chart - "Code 42"
- 1982 Chart - "EGR Valve Check - 3.0L V6"
- 1982 Chart - "TCC Electrical Diagnosis"
- 1982 Chart 2
- 1981 Chart - "Code 34"
- EFI
- Engine Controls - Updated Rough/Unstable Idle Chart
- Computer & Controls - Integrator/Block Learn Operation
- Engine Controls - TPS Specifications
- Idle Speed Control Assembly - Repair Kit
- Fuel System - Revised Mixture Control Adjustments
- ECM - Revised Replacement Procedure
- ECM - Packard 32 Way Connector Identification
- ECM - Packard 32-Way Connector Identification
- Oxygen Sensors - Silica Contamination
- Engine - Poor Driveability/Fuel Mileage
- Coolant Temperature Sensor - Sensor Kit
- PROM/MEMCAL - Identification Marks
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
