Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Plymouth Neon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Remote Keyless Entry Module
NOTE:
A scan tool is required for programming Remote Keyless Entry (RKE) module.
- Ensure ignition is off. Connect scan tool to Data Link Connector (DLC). DLC is located on bottom of instrument panel, to left of brake pedal. See Figure. Turn ignition switch to RUN position.
- Using scan tool, select THEFT ALARM, VTSS, MISCELLANEOUS and then CONFIGURE MODULE. Follow scan tool prompts. When configuration (programming) is complete, turn ignition off and disconnect scan tool. Program RKE transmitters into RKE module memory. See REMOTE KEYLESS ENTRY TRANSMITTER .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.