2000 Plymouth Neon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Cycling Switch Center of HVAC housing.
A/C High Pressure Switch On rear of A/C compressor. See Figure .
A/C Low Pressure Switch On expansion valve. See Figure .
Back-Up Lamp Switch (A/T) Integral with park/neutral position switch.
Back-Up Lamp Switch (M/T) On top of transmission. See Figure .
Brake Warning Indicator Switch On master cylinder. See Figure .
Clutch Interlock Switch On clutch pedal bracket.
Engine Oil Pressure Switch On right side of engine block.
Park/Neutral Position Switch On left side of transmission. See Figure .
Power Steering Pressure Switch On power steering gear. See Figure .
Seat Belt Switch Under driver's seat.
Stoplight Switch Top of brake pedal support.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.