Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Plymouth Colt Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Alignment Specifications: Precis
WHEEL ALIGNMENT SPECIFICATIONS (PRECIS)
| Application | Preferred | Range | |
|---|---|---|---|
| Camber (Degrees) | |||
| Front | 0 | -1/2 to 1/2 | |
| Rear | -11/16 | -1 to -3/16 | |
| Caster (Degrees) | |||
| With P/S | 1 11/16 | 1 3/16 to 2 3/16 | |
| Without P/S | 1 | 1/2 to 1 1/2 | |
| Toe-In (In. (mm)) | |||
| Front | 1/32 (1) | -1/16 to 5/32 (-2 to 4) | |
| Rear | 0 (0) | N/A | |
| Toe-In (Degrees) | |||
| Front | 1/16 | -1/8 to 5/16 | |
| Rear | 0 | N/A | |
| Toe-Out on Turns (Degrees) | |||
| Inner | 37 3/8 | N/A | |
| Outer | 31 1/2 | N/A | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
