1991 Plymouth Colt Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Colt Vista

WHEEL ALIGNMENT SPECIFICATIONS (COLT VISTA)

Application Preferred Range
Two Wheel Drive
Camber (Degrees)
Front 7/16 -1/16 to 15/16
Rear -9/16 -1 1/8 to 0
Caster (Degrees) 13/16 5/16 to 15/16
Toe-In (In. (mm))
Front & Rear 0 (0) -1/8 to 1/8 (-3 to 3)
Toe-In (Degrees)
Front & Rear 0 -1/4 to 1/4
Toe-Out on Turns (Degrees)
Inner 37 3/4 N/A
Outer 30 11/16 N/A
Four Wheel Drive
Camber (Degrees)
Front 13/16 5/16 to 15/16
Rear 0 -1/2 to 1/2
Caster (Degrees) 13/16 5/16 to 15/16
Toe-In (In. (mm))
Front & Rear 0 (0) -1/8 to 1/8 (-3 to 3)
Toe-In (Degrees)
Front & Rear 0 -1/4 to 1/4
Toe-Out on Turns (Degrees)
Inner 37 3/4 N/A
Outer 30 11/16 N/A
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.