Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Plymouth Sundance Base, 2D Hatchback, 2.5 J, AutomaticFACTORY OEM SERVICE PROCEDURE
Labor Times: Other Variant
WARNING: This page is about the Sundance Base, 2D Hatchback, 2.2 D, Automatic, which is a different variant/trim than selected.
- Accessories and Equipment
- Anti-theft Systems
- Cruise Control Systems
- Exterior Lights
- Gauges and Instrument Panels
- Ammeter
- Coolant Temperature Gauge (Dash Unit)
- Coolant Temperature Sender Or Sensor
- Fuel Gauge (Dash Unit)
- Fuel Gauge Tank Unit
- Instrument Cluster
- Instrument Cluster Printed Circuit
- Oil Pressure Gauge (Dash Unit)
- Oil Pressure Indicator Bulb
- Oil Pressure Sender Or Switch
- Speedometer Cable & Housing
- Speedometer Head
- Speedometer Sensor
- Tachometer Head
- Turbocharger Boost Pressure Gauge
- Voltmeter
- Headlights
- Heated Glass and Defoggers
- Ignition Switches and Steering Locks
- Mirrors
- Seats
- Warning Systems
- Window Motors and Regulators
- Wiper & Washer Systems
- Brakes
- Drivelines and Axles
- Electrical
- Engine Mechanical
- Auxiliary Emission Control Systems
- Blowers, Superchargers and Turbochargers
- Cooling Fan
- Cooling System (Mechanical)
- Exhaust
- Fuel Systems
- Lubrication Systems
- Mechanical
- Balance Shaft Sprocket
- Camshaft
- Camshaft Bearing Set
- Camshaft Oil Seal
- Camshaft Or Oil Galley Plug
- Connecting Rod Bearings
- Crankshaft
- Crankshaft Main Oil Seal
- Crankshaft Oil Seal
- Crankshaft Oil Seal Retainer
- Crankshaft Pulley
- Cylinder Head Gasket
- Engine Assembly
- Engine Assembly (Complete)
- Engine Or Transmission Mount
- Engine Torque Mount
- Intermediate Shaft
- Intermediate Shaft Seal
- Intermediate Shaft Sprocket
- Long Block
- Main Bearings
- Piston Ring Set
- Rocker Arm Assembly
- Short Block
- Timing Belt
- Timing Belt TENSIONER
- Valve
- Valve Cover Gasket
- Valve Lifters
- Valve Spring Or Seal
- Starters
- Engine Performance
- Fuel Delivery System
- Air Charge Temperature Sensor
- Air Cleaner Element
- Air Flow Sensor
- Ambient Temperature Sensor
- Camshaft Position Sensor
- Coolant Temperature Sensor
- Crankshaft Position Sensor
- Deceleration Solenoid Valve
- Electronic Control Module
- Engine Idle Speed
- Fuel Injection System
- Fuel Injector
- Fuel Pressure Regulator
- Idle Speed Control Motor
- Intake Manifold
- Intake Manifold Gasket
- Knock Sensor
- Manifold Absolute Pressure Sensor
- Oxygen Sensor
- Throttle Body Assembly
- Throttle Body Temp Sensor
- Throttle Position Sensor
- Vehicle Speed Sensor
- Ignition Systems
- Camshaft Position Sensor
- Crankshaft Position Sensor
- Distributor Assembly
- Distributor Cap
- Electronic Ignition Breaker Assembly
- Electronic Ignition Pick-Up
- Engine Compression
- Engine Cylinder Leakage
- Engine Performance
- Ignition Coil
- Ignition Timing
- Power Control Module
- Spark Plug Wire Set
- Spark Plugs
- Top Dead Center (TDC) Sensor
- Fuel Delivery System
- Heating, Ventilation & A/C (HVAC)
- A/C Compressor
- Heater
- Manual HVAC System
- Restraints
- Steering
- Suspension
- Transmission
- Automatic Trans
- Accumulator Piston
- Differential Assembly
- Differential Cover Gasket
- Extension Housing Seal
- KICKDOWN Band
- KICKDOWN Servo
- KICKDOWN Switch
- Main Control Valve Body
- Neutral Safety Switch
- Parking Lock Rod
- Parking Sprag
- Reverse Servo
- Speedometer Driven Gear
- Throttle Linkage
- Throttle Valve Lever Shaft Seal
- Transaxle Assembly
- Transaxle Electronic Controller
- Transaxle Oil Filter
- Transaxle Oil Pan Gasket
- Transmission
- Transmission Assembly
- Valve Body Lever Shaft Seal
- Clutch Manual and Hydraulic
- Manual Trans
- Automatic Trans
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.