Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Distance (Speed) Sensor
This sensor is located on transaxle extension housing. The sensor generates 8 pulses per axle shaft revolution. The SMEC will interpret distance (speed) sensor input along with throttle position sensor closed throttle input.
This will allow SMEC to differentiate between closed throttle decel and closed throttle idle (vehicle stopped) conditions. During decel, SMEC controls Automatic Idle Speed (AIS) motor to maintain a desired manifold absolute pressure value. During idle (vehicle stopped), the SMEC controls AIS motor to maintain a desired idle speed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.