Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Plymouth Colt BaseFACTORY OEM SERVICE PROCEDURE
Remove, Overhaul & Install: Remove/Install/Overhaul: Introduction: Carburetor: Reassembly
- To reassemble, reverse disassembly procedure. Ensure that all air and fuel passages are clear. Lubricate linkage after cleaning. Check throttle and choke linkage for smooth operation.
- If a main or pilot jet needs to be replaced, make sure replacement jet is of the same size. A number is stamped on each jet.
- To prevent carburetor-to-intake manifold gasket from being installed incorrectly, match holes of gasket to throttle body. Place gasket on intake manifold.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.