Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Plymouth Horizon AutomaticFACTORY OEM SERVICE PROCEDURE
EGR Solenoid
- Ensure that all vacuum hoses are routed properly, correctly connected and not leaking. Disconnect electrical plug from solenoid valve. Connect either solenoid terminal to ground. Connect other terminal to positive battery terminal.
- This should activate the solenoid valve and shut off control vacuum to the EGR system. You should hear a "click" from the solenoid as it is connected to battery positive terminal.
- To test valve operation, start engine and let it idle. Raise engine speed to about 2000 RPM. Watch EGR control valve stem. EGR control valve stem should move. If stem does not move, replace solenoid.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
