Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1984 Plymouth Conquest AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Injection System - MITSUBISHI: Testing: Notes
NOTE:
The Mitsubishi ECI system requires a special tester (Mitsubishi ECI Checker - MD998406) to be fully diagnosed. However, some checks of individual components may be made using regular shop test equipment. Components covered in this article pertain only to fuel portion of system. For more complete testing of ECI system, refer to appropriate Computerized Engine Controls article in Computer Controls section.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
