Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Plymouth Sapporo Automatic TransFACTORY OEM SERVICE PROCEDURE
Blower Motor: Replacement
- Disconnect battery negative cable and blower motor feed wire. Remove glove box and plenum mounting brace on Cordoba and Mirada models.
- Remove blower mounting nuts and screws. On Gran Fury, New Yorker and Diplomat models, separate lower motor housing from upper housing, and remove blower motor mounting plate screws. On all models, remove blower motor assembly. To install, reverse removal procedures.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.