Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pulley Bearing Replacement
- REMOVE BEARING
With pulley removed as previously described, remove bearing retaining ring (Nippondenso clutch only). Support pulley. Then, use bearing remover to drive out bearing.
Tool Reference No. 5
Pulley Bearing Remover
- INSTALL BEARING
Place dust shield in bearing bore. Support pulley. Then, use bearing installer to drive bearing into pulley. Install retaining ring (Nippondenso clutch) or stake bearing (Warner clutch).
Tool Reference No. 6
Pulley Bearing Installer
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
