1981 Plymouth Champ LS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Pulley Bearing Replacement

NOTE: Manufacturer does not recommend pulley bearing replacement for the Chrysler C-171 compressor. Pulley assembly must be replaced if bearing failure occurs.
  1. REMOVE BEARING 

    With pulley removed as previously described, remove bearing retaining ring (Nippondenso clutch only). Support pulley. Then, use bearing remover to drive out bearing.

    Tool Reference No. 5 

    Fig 1: Removal Of Bearing
    G09361430Courtesy of NOT AVAILABLE

    Pulley Bearing Remover

  2. INSTALL BEARING 

    Place dust shield in bearing bore. Support pulley. Then, use bearing installer to drive bearing into pulley. Install retaining ring (Nippondenso clutch) or stake bearing (Warner clutch).

    Tool Reference No. 6 

    Fig 2: Installation Of Bearing
    G09361431Courtesy of NOT AVAILABLE

    Pulley Bearing Installer

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.