1980 Plymouth Horizon Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Full Electric Choke System: Description

All Omni & Horizon engines require electric power to heat the automatic choke system. An electric heater and switch are sealed within the choke housing. Electric current is supplied to this unit from the oil pressure switch. Above 4 psi oil pressure, the oil sending unit contacts close and power is available to the choke control switch.

At winter temperatures, the choke switch is open to reduce heater output until choke area temperature is relatively warm. It then closes to provide full electric assist to open the choke. In summer temperatures, switch provides maximum choke heater output for a shortened choke on time.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.