Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1980 Plymouth Arrow Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
Detonation Sensor Test
NOTE:
Detonation sensor is used only on Calif. V8 engines.
- Connect a variable timing light to engine. Start engine and run it on second highest step of fast idle cam (at least 1200 RPM).
- Tap lightly on intake manifold near the sensor with a small metal object. Using the timing light, look for a decrease in timing. The amount of decrease will be directly proportional to the strength and frequency of the tapping.
- If sensor fails to perform as specified, replace sensor and repeat test. If new sensor still fails to perform properly, check wiring back to computer.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.