1978 Plymouth Arrow Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Start Timer Advance Timing Test

  1. Connect adjustable timing light to engine so total timing advance can be checked at crankshaft. On 1979 models, connect a jumper wire between carburetor switch and a known good ground. Start engine. 2) On 1976-78 models, set parking brake and apply service brakes. Have an assistant start engine, snap open and close throttle, and immediately place transmission in Drive. Look at timing mark on damper immediately after shifting transmission into Drive.
  2. On all models, continue to observe timing for one minute while adjusting timing light to maintain initial timing. Advance should slowly decrease to initial timing in about one minute.
  3. If timing did not increase and/or decrease to initial timing, replace Spark Control Computer. If timing performed satisfactorily, go to SPEED ADVANCE SCHEDULE TEST . Do not remove timing light or jumper wire (if used).
    1976 SPARK ADVANCE SCHEDULE SPECIFICATIONS

    Test Name (1) Additional Advance (Degrees BTDC or Inches Hg)
    Start Timer Advance (All Models) 5-9
    Throttle Advance (Transducer Out 1 Inch)
      At 75° 7-12
      At 104° 4-7
    Transducer Core Moved Rapidly In And Out 7-12 (1 Second)
    Vacuum Advance (Operating Vacuum Range) (2) 32-35"
    Thermal Ignition Control Advance (3) 18-35"
    (1) Additional advance does not include initial ignition timing.
    (2) After 6 to 9 minutes, 16 in. Hg minimum.
    (3) Within 2 seconds, 14 in. Hg minimum. With Thermal Ignition Control disconnected on some models after march 1, 1976.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.