Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Peugeot 505 GL, AutomaticFACTORY OEM SERVICE PROCEDURE
Labor Times: Other Variant
WARNING: This page is about the 505 Liberte, 4D Sedan, which is a different variant/trim than selected.
- Accessories and Equipment
- Brakes
- Electrical
- Engine Mechanical
- Blowers, Superchargers and Turbochargers
- Cooling Fan
- Cooling System (Mechanical)
- Exhaust
- Fuel Systems
- Glow Plugs
- Lubrication Systems
- Mechanical
- Camshaft
- Crankshaft
- Crankshaft Main Oil Seal
- Crankshaft Oil Seal
- Crankshaft Pulley
- Cylinder Head Gasket
- Cylinder Liners & Gaskets
- Cylinder Liners &/Or O-Rings
- Engine Assembly
- Engine Assembly (Complete)
- Engine Or Transmission Mount
- Piston Ring Set
- Rocker Arm Assembly
- Timing Belt
- Timing Case Cover
- Timing Chain
- Valve
- Valve Clearance
- Valve Cover Gasket
- Valve Lifters
- Valve Stem Seal
- Starters
- Engine Performance
- Fuel Delivery System
- Air Cleaner Element
- Air Flow Sensor
- Air Preheating Element
- Air Preheating Jacket
- Air/Fuel Mixture
- Altitude Sensor
- Auxiliary Air Regulator
- Auxiliary Air Valve
- Cold Start Valve
- Deferred Injection Device
- Diesel Injector Pipes
- Electronic Control Unit
- Electronic Injection Control
- Engine Idle Speed
- Frequency Solenoid Valve Assembly
- Fuel Accumulator
- Fuel Cutoff Solenoid
- Fuel Distribution Pipe
- Fuel Injection Idle Speed
- Fuel Injection Pump
- Fuel Injection System
- Fuel Injector
- Fuel Pressure
- Fuel Pressure Regulator
- Idling Accumulator
- Injection Nozzle Holder
- Injection Pump Hub Bracket
- Injection Pump Point Adjustment
- Intake Manifold
- Intake Manifold Gasket
- Knock Sensor
- Load Sensors
- Micro Switch
- Mixture Regulator
- Oxygen Sensor
- Pump Controls
- Speed Sensor
- Temperature Sensor
- Thermal Time Switch
- Throttle Position Switch
- Throttle Valve Housing
- Voltage Supply Relay
- Ignition Systems
- Fuel Delivery System
- Steering
- Suspension
- Transmission
- Body and Frame
- Drivelines and Axles
- Heating, Ventilation & A/C (HVAC)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.