Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Glow Plug System
Current to glow plugs flows through starter relay to Pre-Heat Control Box (located at center of firewall). A timer in control box provides power to glow plug, depending on ambient temperature, for 10-90 seconds. The following check can be made on this system:
- Check system ground between terminal 2 on control box and frame. Check condition of glow plug bulb and ground connection in instrument panel.
- To locate shorted glow plugs, remove connecting straps between plugs. Connect a heavy jumper wire between terminal 5 of control box and each plug, 1 at a time.
- Leave jumper wire connected for about 2 seconds. If glow plugs are bad, glow plug relay will cycle rapidly on and off. Replace shorted glow plugs.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
