Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Peugeot 604 AutomaticFACTORY OEM SERVICE PROCEDURE
Injection Pump Timing: Notes
- With pump mounting bolts loose, dial indicator attached to No. 4 cylinder exhaust valve, and engine at .28" (7 mm) BTDC, rotate injection pump body away from engine (full retard). See Fuel Injection Pump Installation.
- Clean the hydraulic head and remove the inspection plug. See Figure . Using adapters (8.0117T, P, and S), install dial indicator on pump. Turn engine and locate BDC and TDC points on the pump's dial indicator. At BDC, the pump dial indicator should have some preload.
- Zero the pump dial indicator at BDC. Bring piston No. 4 to TDC of compression stroke. Zero engine dial indicator. Turn engine 90Β° in reverse. Recheck pump dial indicator.
- Turn engine in normal direction of rotation and bring No. 4 piston to .038" (1.35 mm) BTDC for non-turbo models or .016" (.40 mm) BTDC for turbo models. This corresponds to 11Β° BTDC for non-turbo models and 7Β° BTDC for turbo models.
- Rotate pump towards the engine until pump dial indicator indicates a pump lift of .020" (.50 mm). Tighten pump mounting bolts, front and rear.
- Check timing by rotating engine 2 turns in normal direction. Turn engine back approximately 90Β°. Rotate engine slowly in normal direction while watching pump dial indicator.
- Stop turning engine when indicator shows a lift of .020" (.50 mm). No. 4 piston should then be at .038" (.97 mm) BTDC for non-turbo models, and .016" (.40 mm) BTDC for turbo models. If readjustment is necessary, rotate pump.
- Remove dial indicators and supports. Install inspection plug with a new gasket. Install springs, washer and half cones of No. 4 exhaust valve and adjust clearance. Install pipes, hoses, and controls. Adjust cables and bleed fuel circuit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
