Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Oldsmobile Intrigue GLSFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Blower Motor Control Module | In right side of heater-A/C module. See Figure . |
| Body Control Module (BCM) | Behind left side of dash, left of steering column. |
| Cruise Control Module | Front of left strut tower. See Figure . |
| Electronic Brake Control Module (EBCM) | At left side of engine compartment, integral to BPMV. See Figure . |
| Engine Coolant Level Indicator Module | On bottom of coolant surge tank, on left side of engine compartment. |
| Front Bank Ignition Control (IC) Module | On top of left engine valve cover. See Figure . |
| Heated Seat Control Module (2) | Beneath respective front seat. |
| Inflatable Restraint Sensing & Diagnostic Module (SDM) | Below carpet, under right front seat. |
| Powertrain Control Module (PCM) | Left front side of engine compartment, in air cleaner assembly. See Figure . |
| Radio Antenna Module | On rear window header panel, above headliner. |
| Rear Bank Ignition Control (IC) Module | On top of right engine valve cover. See Figure . |
| Remote Control Door Lock Receiver (RCDLR) | Left side of dash, on right side of instrument cluster. |
| Sun Roof Module | Right rear corner of sun roof. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.