Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Oldsmobile Intrigue GLFACTORY OEM SERVICE PROCEDURE
Engine Cooling Diagnostic System Check
- Connect scan tool to Data Link Connector (DLC). See Figure. DLC is located below left side of instrument panel. Turn ignition on. If scan tool powers up, go to next step. If scan tool does not power up, see SCAN TOOL DOES NOT POWER UPΒ under SYSTEM TESTS.
- Using scan tool, attempt to communicate with Instrument Panel Cluster (IPC) and Powertrain Control Module (PCM). If scan tool communicates with IPC and PCM, go to next step. If scan tool does not communicate with IPC and PCM, diagnose communication problem. See TEST F: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS in appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
- Using scan tool, select IPC and PCM display DTCs function. If scan tool displays any DTCs, go to next step. If scan tool does not display DTCs, repair engine cooling system by symptom. See ELECTRIC COOLING FANS - CARS article in ENGINE COOLING.
- If scan tool displays any DTCs that begin with "U", diagnose communication problem. See TEST F: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS in appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT. If scan tool does not display any DTCs that begin with "U", repair other DTCs as necessary. See DIAGNOSTIC TROUBLE CODE DEFINITIONSΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
