2001 Oldsmobile Intrigue GLFACTORY OEM SERVICE PROCEDURE

Test D: Lock-Out Function Inoperative

NOTE: Reviewing system description and operation information will help determine if condition described by customer is normal operation, and may help determine correct symptom diagnostic procedure when a malfunction exists.
  1. If power window system description and operation has been reviewed, go to next step. If description and operation has not been reviewed, see POWER WINDOW SYSTEM  under DESCRIPTION & OPERATION. After power window system description and operation has been reviewed, go to next step.
  2. Operate power windows lock-out function. If lock-out function does not operate properly, go to next step. If lock-out function operates properly, go to DIAGNOSING INTERMITTENTS  .
    3. NOTE: Driver door window switch may be referred to as left front window switch, master window switch or master switch.
  3. Disconnect master switch harness connectors. Turn ignition switch to RUN position. Connect a test light between ground and 5-pin master switch harness connector C2 terminal "A" (Dark Blue wire). See Figure . If test light illuminates, go to next step. If test light does not illuminate, go to step  5 .
  4. Check for short to voltage in Dark Blue wire between 5-pin master switch harness connector C2 terminal "A" and other window switch harness connectors terminal "B". See WIRING DIAGRAMS  . Repair as necessary. After repair, go to step  6 . If no problem is found, go to next step.
  5. Replace master switch. See WINDOW SWITCH  under REMOVAL & INSTALLATION. After repair, go to next step.
  6. Operate system to verify repairs. If system does not operate properly, go to step  2 . If system operates properly, system is okay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.