2001 Oldsmobile Intrigue GLFACTORY OEM SERVICE PROCEDURE

With Scan Tool

NOTE: Following procedure is written specifically for Tech 2 scan tool. A generic scan tool may not be capable of performing all necessary reprogramming functions.
  1. Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, to right of steering column. See Figure . Turn ignition switch to RUN position.
  2. Using scan tool, select BODY, then BODY CONTROL MODULE. Select SPECIAL FUNCTIONS. Select PROGRAM KEY FOBS.
  3. Press and hold LOCK button and UNLOCK button simultaneously on one transmitter. After a delay of 15 seconds, body control module will sound 3 chimes to confirm programming of first transmitter.
  4. Repeat previous step to program up to 4 transmitters. Remove scan tool. Operate transmitter functions to verify correct system operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.