Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Oldsmobile Intrigue GLSFACTORY OEM SERVICE PROCEDURE
Without Scan Tool
- Sit in driver's seat. Close all doors. Remove ignition key from ignition switch. Depress and hold door lock switch to UNLOCK.
- Insert and remove ignition key twice (without turning lock cylinder). Insert ignition key a third time, leaving key in ignition in LOCK position. Release door lock switch. Three fast chimes will be heard when remote control door lock receiver is in programming/diagnostic mode.
- Depress and hold transmitter LOCK and UNLOCK buttons simultaneously for 12 seconds. Two fast chimes will be heard to confirm programming. Repeat with each transmitter to be programmed. Remove key from ignition. Verify system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.