Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Oldsmobile BravadaFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES
| Component | Component Location |
|---|---|
| Anti-Lock Diode | In instrument cluster. |
| Battery Megafuse | On right side of radiator support, below battery. |
| Body Relay Block | Behind left side of dash, near I/P fuse block. |
| Brake Warning Diode | In instrument cluster. |
| Fuse Holder | In engine compartment, right of radiator. |
| I/P Fuse Block | On left end of dash. |
| Power Seats Circuit Breaker | In body relay block. |
| Power Window Circuit Breaker | In body relay block. |
| Secondary Air Injection Reactor Fuse Block | Mounted to right front fender, next to battery. |
| Underhood Fuse Block | On top of left front fender. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.