Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Oldsmobile BravadaFACTORY OEM SERVICE PROCEDURE
Charging System Test
- Turn ignition on. Charge indicator light should stay on and voltmeter should read 12-14 volts. If charge indicator light does not illuminate, go to CHARGE INDICATOR LIGHT NEVER ON . If voltmeter does not read 12-14 volts, go to VOLTMETER DISPLAYING HIGH OR LOW .
- Start engine. If charging system and charge indicator light are operating properly, go to next step. If charge indicator stays on, go to CHARGE INDICATOR LIGHT ALWAYS ON . If voltmeter does not read 13-16 volts, go to VOLTMETER DISPLAYING HIGH OR LOW .
- Turn on headlights, rear defogger and blower motor. If charging system and charge indicator light are operating properly, check is complete. If charge indicator light illuminates and/or voltmeter does not read 13-16 volts, go to VOLTMETER DISPLAYING HIGH OR LOW .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.