1998 Oldsmobile RegencyFACTORY OEM SERVICE PROCEDURE

Left Seat Does Not Manually Recline In Either Direction

NOTE: After repair or component replacement is completed, perform MEMORY SYSTEM CHECKΒ  under TROUBLE SHOOTING to verify system is functioning properly.
  1. Perform MEMORY SYSTEM CHECKΒ  under TROUBLE SHOOTING. Go to next step.
  2. Disconnect left seat switch connector. Using DVOM, check voltage between left seat switch harness connector terminal "F" (Orange wire) and ground. If 10-15 volts exists, go to next step. If 10-15 volts does not exist, go to step 5).
  3. Check voltage between left seat switch harness connector terminals "F" (Orange wire) and "G" (Black wire). If 10-15 volts exists, go to next step. If 10-15 volts does not exist, go to step 6).
  4. Replace left seat switch.
  5. Repair open or short to ground in Orange wire between left seat switch and instrument panel fuse block.
  6. Repair open in Black wire between left seat switch and ground.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.