1998 Oldsmobile RegencyFACTORY OEM SERVICE PROCEDURE

Mirror Does Not Manually Move Left Or Right

NOTE: After repair or component replacement is completed, perform MEMORY SYSTEM CHECK  under TROUBLE SHOOTING to verify system is functioning properly.
  1. Perform MEMORY SYSTEM CHECK  under TROUBLE SHOOTING. Go to next step.
  2. Turn ignition switch to OFF position. Ground memory seat diagnostic connector. Memory seat/mirror module will chime once to indicate Mode 1 has been entered. Operate left outside mirror switch in all directions. Memory seat/mirror module should chime once at each switch input. If any switch input does not cause a chime to sound, go to step 6). If all switch inputs cause a chime to sound, go to next step.
  3. On left mirror, check for open in White wire between left outside mirror and memory seat/mirror module 6-pin connector C3 (Gray). On right mirror, check for open in Red/White wire between right outside mirror and memory seat/mirror module 6-pin connector C3 (Gray). If circuit is okay, go to next step. If circuit is not okay, go to step 8).
  4. On left mirror, check for open in Light Blue wire between left outside mirror and splice S506. On right mirror, check for open in Gray wire between right outside mirror and splice S600. If circuit is okay, go to next step. If circuit is not okay, go to step 8).
  5. Replace mirror left/right motor. To remove power mirror assembly, see MIRRORS - POWER article.
  6. On left mirror, check for open in White wire between left outside mirror switch and memory seat/mirror module 32-pin connector C2 (Blue). On right mirror, check for open in Red/White wire between left outside mirror switch and memory seat/mirror module 32-pin connector C2 (Blue). If circuit is okay, go to next step. If circuit is not okay, go to step 8).
  7. Replace left outside mirror switch. See MIRRORS - POWER article.
  8. Repair open in appropriate wire. See WIRING DIAGRAMS  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.