Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Oldsmobile Intrigue BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Procedures
- If BCM diagnostic system check was performed, go to next step. If BCM diagnostic system check was not performed, see procedures in BCM DIAGNOSTIC SYSTEM CHECK .
- Perform theft deterrent relearn procedures. See procedures in BCM PROGRAMMING . After performing relearn procedures, go to step 4).
- Using scan tool, check for PASSLock(R) related DTCs B2722 or B2723. If any of this DTC is present, diagnose affected DTC(s). If these DTCs are not present, go to step 5).
- Using scan tool, clear DTCs. Check DTCs. If DTC B2735 is set as current DTC, go to step 3). If DTC B2735 is not present, system is okay.
- Replace BCM. Perform new BCM setup procedures. See procedures in BCM PROGRAMMING . After programming BCM, go to next step.
- Turn ignition off. Reinstall all components and connectors. Turn ignition switch to RUN position. Using scan tool, clear DTCs. After clearing DTCs, perform BCM DIAGNOSTIC SYSTEM CHECK .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.