Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Oldsmobile Intrigue BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Procedures
- If BCM diagnostic system check was performed, go to next step. If BCM diagnostic system check was not performed, SEE procedures in BCM DIAGNOSTIC SYSTEM CHECK .
- Turn ignition off. Disconnect BCM harness connector C1. Using DVOM, check resistance between BCM harness connector C1, terminal C9 (Pink/White wire) and ground. See WIRING DIAGRAMS . If continuity is present, go to step 5). If continuity is not present, go to step 6).
- Disconnect DRL control module harness connector, located under left side of dash, left of steering column. Leave DVOM connected as specified in step 2). If continuity is present, go to step 5). If continuity is not present, go to step 6).
- Reconnect BCM harness connector. Disconnect DRL control module harness connector. Using a test light connected to battery voltage, backprobe DRL module harness connector terminal "B" (Pink/White wire). If test light illuminates, go to step 6). If test light does not illuminate, go to step 7).
- Repair short to ground in circuit No. 1970 (Pink/White wire) between BCM harness connector and DRL harness connector. After repairs, go to step 10).
- Replace DRL control module. After replacing DRL control module, go to step 10).
- Disconnect BCM harness connector C1. Using DVOM, check continuity of circuit No. 1970 (Pink/White wire). If continuity is present, go to next step. If continuity is not present, go to step 9).
- Replace BCM. Perform new BCM setup. See BCM PROGRAMMING . After programming BCM, go to step 10).
- Repair poor connection or open in circuit No. 1970 (Pink/White wire) between BCM harness connector terminal C9 and DRL control module connector terminal "B". After repairs, go to next step.
- Turn ignition off. Reinstall all components and connectors. Turn ignition switch to RUN position. Using scan tool, clear DTCs. After clearing DTCs, perform BCM DIAGNOSTIC SYSTEM CHECK .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
