Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Oldsmobile Intrigue BaseFACTORY OEM SERVICE PROCEDURE
With Scan tool
- Connect scan tool to DLC.
- Turn ignition to RUN position. At APPLICATION MENU, select "F5" (PERSONALIZATION).
- At PERSONALIZATION MAIN menu, select "F0" (SET OPTIONS).
- At SET OPTIONS MAIN menu select "F3" (VERIFY LOCK MODE).
- After reading SETTING OPTIONS screen, select "Done".
- At SET OPTIONS screen use up and down arrow buttons to select desired option
- Select "Activate Options" then select "Save Options".
- Press "Exit" repeatedly until "Application Menu" is viewed.
- Disconnect scan tool from DLC. Verify system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.