1998 Oldsmobile Cutlass BaseFACTORY OEM SERVICE PROCEDURE

Component Locations

NOTE: Component location illustrations are not available for Malibu.
COMPONENT LOCATIONS (VIN M)

Component Location
A/C Compressor Relay Left Side Of Engine Compartment, In Power Distribution Box
A/C Pressure Sensor Front Of Engine Compartment
Camshaft Position (CMP) Sensor Top Rear Of Engine
Crankshaft Position (CKP) Sensor
7X Lower Rear Of Engine
24X Lower Front Of Engine
Cruise Control Module Right Side Of Engine Compartment
Data Link Connector Under Left Side Of Instrument Panel
EGR Valve Top Rear Of Engine
Engine Coolant Temperature (ECT) Sensor Top Rear Of Engine
Engine Oil Level Switch Rear Of Engine
Engine Oil Pressure Sensor Front Of Engine
EVAP Canister Purge Solenoid Top Rear Of Engine
EVAP Canister Vent Under Rear Of Vehicle
Fan Control Relays No. 1 & 2 Left Side Of Engine Compartment, In Power Distribution Box
Fuel Injectors In Intake Manifold
Fuel Pump Relay Left Side Of Engine Compartment, In Power Distribution Box
Fuel Tank Pressure Sensor In Fuel Tank
Idle Air Control (IAC) Valve Top Left Side Of Engine
Ignition Control Module Top Rear Of Engine
Intake Air Temperature (IAT) Sensor Top Left Side Of Engine
Knock Sensor On Front Of Engine
Manifold Absolute Pressure (MAP) Sensor Top Rear Of Engine
Mass Airflow (MAF) Sensor Top Left Side Of Engine
Mode Control Relay Left Side Of Engine Compartment, In Power Distribution Box
Oxygen Sensors (O2S)
Pre-Converter Top Rear Of Engine, In Left Exhaust Manifold
Post-Converter Rear Of Catalytic Converter
Power Distribution Box On Left Side Of Engine Compartment
Powertrain Control Module (PCM) Below Left Side Of Instrument Panel, Near Steering Column
Throttle Position (TP) Sensor Top Left Side Of Engine
Transaxle Range Switch Left Side Of Engine/Transaxle
Vehicle Speed Sensor Rear Of Engine/Transaxle
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.