1998 Oldsmobile AuroraFACTORY OEM SERVICE PROCEDURE

Express Down Does Not Operate

NOTE: Improper operation of express down function may occur if excessive effort is necessary to move window up and down. This may be caused by an improperly wound window regulator spring or worn or misadjusted regulator.
  1. Disconnect express down module connector, located at front of left front door. Turn ignition switch to RUN position. Connect test light between ground and express down module connector terminal "C" (Dark Blue wire). If test light illuminates, go to next step. If test light does not illuminate, repair open in circuit No. 164 (Dark Blue wire) between express down module and splice S503.
  2. Replace express down module. Recheck express down operation. If express down operates properly, system is okay. If express down does not operate properly, check for improperly wound window spring. To check, place left front window in full up position. Inspect window regulator counterbalance spring for proper winding. See Fig 1 . If spring winding is incorrect, rewind spring.
    Fig 1: Identifying Window Regulator Counterbalance Spring Winding
    G98E00434Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.