Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Oldsmobile Aurora V8-4.0L VIN CFACTORY OEM SERVICE PROCEDURE
Test Light/Digital Voltmeter
Use a test light to check for voltage. A Test Light (J 34l42-B) is made up of a 12 volt light bulb with a pair of leads attached. After grounding one lead, touch the other lead to various points along the circuit where voltage should be present. When the bulb goes ON, there is voltage at the point being tested.
A Digital Voltmeter (DVM) can be used instead of a test light. While a test light shows whether or not voltage is present, a DVM indicates how much voltage is present.
An increasing number of circuits include solid state control modules. One example is the Engine Control Module (ECM). Voltages in these circuits should be tested only with a 10-megohm or higher impedance DVM or multimeter (J 39200). Unless directed to within the diagnostics, NEVER use a test light on circuits that contain solid state components, since damage to these components may result.
When testing for voltage or continuity at the connection, it is not necessary to separate the two halves of the connector. Unless testing a Weather Pack(R) connector, always probe the connector from the back. Always check both sides of the connector. An accumulation of dirt and corrosion between contact surfaces is sometimes a cause of electrical problems. Refer to Procedures in checking terminal contact. Checking Terminal Contacts
A Digital Voltmeter (DVM) can be used instead of a test light. While a test light shows whether or not voltage is present, a DVM indicates how much voltage is present.
An increasing number of circuits include solid state control modules. One example is the Engine Control Module (ECM). Voltages in these circuits should be tested only with a 10-megohm or higher impedance DVM or multimeter (J 39200). Unless directed to within the diagnostics, NEVER use a test light on circuits that contain solid state components, since damage to these components may result.
When testing for voltage or continuity at the connection, it is not necessary to separate the two halves of the connector. Unless testing a Weather Pack(R) connector, always probe the connector from the back. Always check both sides of the connector. An accumulation of dirt and corrosion between contact surfaces is sometimes a cause of electrical problems. Refer to Procedures in checking terminal contact. Checking Terminal Contacts
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.