Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Oldsmobile RegencyFACTORY OEM SERVICE PROCEDURE
Component Locations
WARNING: This page is about a different car, the 1997 Oldsmobile Aurora and 1997 Buick Riviera. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Maint Power Distribution Center/Maxi-Fuse Block | Right Front Corner Of Engine Compartment |
| Instrument Panel Fuse Block | Left Front Of Passenger Compartment, Attached To Door Hinge Pillar |
| Park/Neutral Position Switch | Left Center Of Engine Compartment, On Transaxle |
| Pass-Key(R) II Decoder Module | Behind Right Side Of Instrument Panel |
| Powertrain Control Module (PCM) | Behind Right Side Of Instrument Panel, Near HVAC Programmer |
| Right Rear Power Distribution Center Fuse Block No. 1 & 2 | Left Side, Under Rear Seat |
| Starter Enable Relay | Behind Left Side Of Instrument Panel, On Bracket Left Of Steering Column |
| Starter Motor On Oldsmobile | Top Of Engine, Under Intake Manifold |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
