1997 Oldsmobile RegencyFACTORY OEM SERVICE PROCEDURE

Circuit Description

Knock Sensor (KS) module is located in PCM and is replaceable. KS module reads KS to determine if excessive detonation (knock) is present. If excessive knock is present, PCM will retard timing until knock goes away. When KS module is missing or malfunctioning, PCM will set DTC P0325.

Conditions required to set DTC are:

  • No fuel injector, misfire or TP sensor DTCs set.
  • Engine running at least 10 seconds.
  • ECT greater than 149Β°F (65Β°C).
  • PCM detects problem with KS module causing knock to be indicated continuously.
  • Listed conditions present for up to 2.5 seconds.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.