Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Oldsmobile RegencyFACTORY OEM SERVICE PROCEDURE
Starter Specifications
HOLD-IN WINDINGS SPECIFICATIONS
| Engine | Starter Motor | Amps | ||
|---|---|---|---|---|
| 3.8L | SD255 | (1) 10-20 | ||
|
||||
PULL-IN WINDINGS SPECIFICATIONS
| Engine | Starter Motor | Amps | ||
|---|---|---|---|---|
| 3.8L | SD255 | (1) 60-85 | ||
|
||||
STARTER NO-LOAD TEST SPECIFICATIONS
| Application | Starter | (1) Amps | RPM | ||||
|---|---|---|---|---|---|---|---|
| 3.8L | SD255 | (2) 45-75 | 8600-13,000 | ||||
|
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.