1997 Oldsmobile Cutlass BaseFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
ABS Modulator-To-Master Cylinder Through-Bolts 17 (23)
ABS Modulator Mounting Nut 22 (30)
EBCM/EBTCM Mounting Bolt/Nut 8 (11)
Master Cylinder-To-Vacuum Booster Nut 20 (27)
Modulator Brake Pipe Fitting 18 (25)
Wheel Lug Nuts 100 (136)
INCH Lbs. (N.m)Β 
Brake Caliper/Cylinder Bleeder Valves
Front 115 (13)
Rear 62 (7)
Modulator Bleeder Valves 80 (9)
Modulator Gear Cover Screws 35 (4)
Modulator Gear Retaining Nut 75 (8.5)
Motor Pack-To-Modulator Screws 40 (4.5)
Solenoid-To-ABS Modulator Screws 40 (4.5)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.