Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Oldsmobile AuroraFACTORY OEM SERVICE PROCEDURE
Left Front Window Does Not Operate
- Disconnect express down module connector, located at center of left front door. Turn ignition switch to RUN position. Connect test light between ground and Brown wire terminal (power) at express down module connector. If test light is on, go to next step. If test light is off, repair open in Brown wire between power window 25-amp circuit breaker and express down module.
- Connect test light between Gray wire and Dark Blue wire terminals at express down module connector. If test light is off, go to next step. If test light is on, replace master switch (shorted left front window switch).
- Press left front window switch at master switch to up and down positions. If test light is on, go to next step. If test light is off, repair open in Gray wire or Dark Blue wire between master switch and express down module. If wire is okay, replace master switch.
- Disconnect left front window motor connector. Connect test light between ground and Dark Blue wire terminal at left front window motor connector. Press left front window switch at master switch to up position. If test light is on, go to next step. If test light is off, repair open in Dark Blue wire between left front window motor and express down module.
- Reconnect left front window motor connector. Connect a fused jumper between Brown wire terminals (power and left front motor connection) at express down module connector. If left front window motor operates, go to next step. If left front window motor does not operate, repair open in Brown wire between express down module and left front window motor. If wire is okay, replace motor.
- Connect a fused jumper between ground and Brown wire terminal (left front motor connection) at express down module. Press left front window switch at master switch to up position. If left front window motor operates, replace express down module. If left front window motor does not operate, replace motor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
