1990 Oldsmobile Custom CruiserFACTORY OEM SERVICE PROCEDURE

Block-Out Switch Test

  1. Put ignition switch in RUN position. Put tailgate power window control switch in RAISE position. Leave tailgate block-out switch connector connected and measure voltage at connector between Dark Blue wire and ground. If battery voltage is not present, check/repair Dark Blue and Light Blue wires for opens.
  2. Move tailgate key switch to RAISE position. Again measure voltage between Dark Blue wire and ground. If battery voltage is not present, check/repair Dark Blue and Light Blue wires for opens.
  3. With tailgate key switch still in RAISE position, measure voltage between Light Blue wire and ground. If battery voltage is not present, check tailgate block-out switch adjustment. If adjustment is correct, replace tailgate block-out switch. See ADJUSTMENTSΒ  in this article.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.