1986 Oldsmobile ToronadoFACTORY OEM SERVICE PROCEDURE

Riviera Models

After the "Service Mode" is entered any trouble codes stored in the computer memory will be displayed. ECM codes will be displayed first. If no ECM codes are stored, the CRT will display "NO ECM CODES" for approximately 2 seconds.

After the ECM codes have been displayed the BCM codes will be displayed. BCM codes will also be accompanied by "Current" or "History". "History" indicates that the failure was not present when last tested, "Current" indicates the fault still exists. This type of information helps in the diagnosis of intermittent problems. If no BCM codes are present, the BCM will display the "NO BCM CODES" message. Trouble codes for both the ECM and BCM will be displayed in numerical succession of lowest too highest numbered code.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.