Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Oldsmobile ToronadoFACTORY OEM SERVICE PROCEDURE
Code EO42, C(3)I Ignition System
Code EO42 means the ECM has seen an open or grounded by-pass or EST circuit with the engine running, or an active ESC circuit during cranking.
- Checks to see if ECM recognizes a problem. If it doesn't set Code EO42 at this point, it is an intermittent problem and could be due to a loose connection.
- With the ECM disconnected, the ohmmeter should be reading less than 200 ohms, which is normal resistance of the ignition module.
- Checks to see if ignition module switches when the by-pass circuit is energized by 12 volts through the test light. If the ignition module actually switches, the ohmmeter switches to over 8000 ohms.
- Disconnecting the ignition module should make the ohmmeter read as if it were seeing an open circuit. If the ohmmeter has a low reading, circuit 423 is shorted to ground.
- Checks to see if ECM recognizes a problem. If it doesn't set Code EO42 at this point, it is an intermittent problem and could be due to a loose connection.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
