1966 Oldsmobile Dynamic Base, Eng CD ML, Automatic TransFACTORY OEM SERVICE PROCEDURE

Engine Code Location

Engine Code is stamped on right side of engine block, directly to rear of distributor on all 6-cylinder engines. V8 engines are identified by a code tape installed directly above unit number, which is stamped on engine oil fill tube.

Engine Code Letters
250" 6-Cyl. 1-Bbl. CCC, CCA, CCB, CCD
350" V8 4-Bbl. QW, QB, QC, QL, QQ QU, TB, TC, TL, TO
455" V8 4-Bbl. UL, UU, UX, UA, UC, UD UB, UN, UR, UO, UP, VL VA, VC, VB, VD, VO, VP
Fig 1: 1973-74 6 CYL. ENGINE CODE LOCATION
G09340433Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.