SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM (1 OF 2)BASIC INSPECTIONSTARTER OPERATION COUNTER CLEARWORK PROCEDURE
2024 Nissan-Datsun Frontier SL, RWD

Work Procedure

2024 Nissan-Datsun Frontier SL, RWDSECTION Work Procedure
  1. ERASE STARTER OPERATION COUNTER 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
    2. Select "STRT OPRTN CNTR CLEAR" in "WORK SUPPORT" mode of "ENGINE" using CONSULT.
    3. Touch "CLEAR" and erase starter operation counter.

    SYMBOL Without CONSULT

    NOTE: SYMBOL
    • It is better to count the time accurately with a clock.
    • It is impossible to switch the diagnostic mode when an accelerator pedal position sensor circuit has a malfunction.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
    3. Repeat the following procedure quickly five times within 5 seconds.
      • Fully depress the accelerator pedal.
      • Fully release the accelerator pedal.
    4. Wait 7 seconds, repeat the following procedure quickly five times within 5 seconds.
      • Fully depress the accelerator pedal.
      • Fully release the accelerator pedal.
    5. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds.
    6. Fully release the accelerator pedal and turn the ignition switch OFF.
      GNSDB133885Courtesy of NISSAN NORTH AMERICA, INC.

    >>

    INSPECTION END

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.