CONSULT can display each diagnostic item using the diagnostic test modes shown following:

Diagnosis mode	CGW Status			Description
Diagnosis mode	Restricted Mode	Diag Test Mode	Open Mode	Description
Self Diagnostic Result	Display	Display	Display	Display non-network DTC which EPS control unit memorizes
CGW Information	Display	Display	Display	Display the current CGW mode Enables CGW to switch mode
Data Monitor	Display	Display	Display	Displays EPS control unit input/output data in real time
ECU Identification	Display	Display	Display	Displays EPS control unit part number
Configuration	Display	Display	Display	The vehicle specification that is written in EPS control unit can be displayed or stored The vehicle specification can be written when EPS control unit is replaced
Network-DTC	Display	Display	Display	Display network DTC which EPS control unit memorizes when performing "Diagnosis (All System)".
CAN Diag Support Monitor ^*	Display	Display	Display	NOTE: The mode is indicated, but not monitored

*: Displays when performing "Diagnosis (All System)".

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Application Items